Important Notice
After equipment is installed, remove all film from labels. Ensure all bolts are tightened, and installation is complete before use.
Surface Mount Installation
Installation Steps
- Position equipment on concrete pad
- Mark anchor hole locations
- Drill holes to required depth
- Clean holes thoroughly
- Install epoxy or chemical anchors
- Set equipment and insert bolts
- Tighten all hardware securely
- Install bolt caps/Base cover
In-Ground Mount Installation
Important Instructions
- Attach embedded anchors to bottom of posts before placing in footers
- All bolts are pre-attached to anchors
- Ensure equipment is level before concrete sets
Footing Requirements
Installation Steps
FOR SOFTER SOIL CONDITIONS, WE RECOMMEND 30” L x 30” W x 24” H.